Staging preview, not public. Photo spots and anything highlighted in yellow are still waiting on Lucas.

Hot Tub Openings and Closings in the Northwest Suburbs

If you don't use your tub in winter, closing it properly in fall is what keeps the plumbing from cracking. In spring, I start it back up, check it over and balance the water.

Many people around here keep their tubs running all winter, and that works as long as the power stays on. Others would rather shut down for the season. If that's you, the closing is what matters. A hot tub can't just be drained and left. Water sits in the low spots of the plumbing, in the pump housings and in the heater, and one cold January night is enough to crack them. A proper closing gets that water out.

Opening in spring is more than filling it back up. It's the first close look at the tub since fall, so it's when freeze damage, mouse nests and dried-out seals show up. I reconnect the plumbing, refill, bleed out trapped air, start the equipment and watch for leaks before balancing the water. Spring is also a good time to replace a tired filter or take a look at a cover that soaked up water over the winter.

What people ask me for

  • Closing a tub they won't use until spring
  • Winterizing before a long trip or a winter away
  • Shutting down a tub at a second home or cabin
  • Opening a tub that sat closed all winter
  • Checking for freeze damage before the first fill
  • Starting up a used tub, or one that came with a new house

What a closing and an opening involve

Flush and drain

Before draining, I run a line flush through the plumbing to loosen buildup, then drain the tub and sponge out what is left in the footwell.

Get the water out of the equipment

I loosen the unions, drain the pumps and heater, and blow out the jet lines and plumbing so no standing water is left to freeze. The filters come out and go indoors to dry.

Close it up

The power is turned off at the breaker, the panels go back on, and the cover is closed and locked to keep out snow, water and critters.

Spring start-up

I check the plumbing and equipment, tighten everything back up, and refill through the filter well to limit air locks. Then I power it up and bleed any trapped air.

Leak check and water balance

I watch for leaks as it fills and heats, then balance the alkalinity and pH and bring the sanitizer up into range.

Close it before the first hard freeze

In northern Illinois, the first hard freeze often arrives in late October or early November. If you plan to shut the tub down, do it while the weather is still mild instead of waiting for the first cold night. Until then, keep it running and covered so its freeze protection can do its job.

FAQ

Openings and Closings: common questions

Should I winterize my hot tub or keep it running?

Both work. A running tub with a good cover, healthy water and steady power uses its own heat and freeze protection to stay safe, and you get to use it on snowy nights. The risk is a long outage or a tripped GFCI during a cold snap. If you won't use it, or you'll be away for weeks, closing it is the safer choice. The key is not to leave it half done.

Can I just drain my hot tub for the winter?

Draining alone isn't enough. Water stays trapped in the pumps, the heater, the low points of the plumbing and the jet lines. When it freezes, it expands and can crack housings and fittings, and you won't know until you refill in spring. A proper closing removes that water by draining the equipment and blowing out the lines, so nothing is left sitting where it can freeze.

Is antifreeze safe to use in a hot tub?

Only the non-toxic propylene glycol kind sold for RVs and plumbing. Never use automotive antifreeze. The RV type can go into low spots and lines that are hard to clear completely, as a backup to blowing out the lines, not a replacement for it. It has to be flushed out in spring before the tub is refilled and used.

What happens at a spring opening?

I start by looking over the equipment and plumbing for anything that cracked or shifted over the winter, and for signs of mice. Then the unions get tightened, the drain gets closed and the tub is refilled through the filter well. Once it is running, I bleed any air locks, check every pump and the heater, and watch for leaks. The last step is balancing the water and adding sanitizer.

Request a quote

Tell me what is going on with your hot tub and I will get back to you. A photo of the equipment label or the error code helps. In a hurry? Call (224) 357-7149.

The error code, the equipment, or the label inside the cabinet door.

Your details go to Lucas, to answer your request. See the privacy page.

Call Lucas Get a quote